Replace Your Old Hangers with New Double Traverse Rods

Although enhancing their living rooms, men and women normally choose to install curtain rods that can seamlessly match using the general decor of the residence. These days, you will find different designs of rods accessible. It is possible to either wish to buy straightforward Decorative Curtain Rods or traverse curtain rods that come with a pulley method, which makes it easy to open and close the drapes by just pulling the wand. Several of the hardware of these rods operates by way of a side draw whereas other people make use of center draw.

The layout on the drapes while utilizing these rods will likely be such that an S-shaped pin attaches towards the pleats on your drapes with a Curtain Hook end that may be seen by way of the small hole in the hanger. Since the hangers used are produced of plastic, they could break or put on out very easily when exposed to sun or with all the passage of time. Nevertheless, these hangers will not be extremely pricey and can be very easily purchased and installed in just a few minutes time. Once they grow of their age, you are able to replace them to initiate a correct functioning of your rods and curtains.

This short article discusses strategies by way of which it is possible to replace your old, worn-out hangers with new ones.

Whether you might be using single or double traverse rods, it's initial needed for you to detach the panels on the drapes in the corner of the bracket to expose the traverse rod on the side which has the Curtain Hangers broken. By lifting the hooks, continue to eliminate the drapes in the corner of bracket.

Once you're done with their removal, now detach the hooks from the hangers and set the drape in one particular side to expose the hardware, rod and ring hangers. To avoid the loss of any pins, which might be stuck in the seams from the pleats, fold the drapes and hold them aside. Nonetheless, in case you believe that your curtains need some cleaning, cautiously eliminate the hooks and from the pleats.

The subsequent step is always to unlock the rod, which could be carried out by pressing down the tab on the pulley located around the either side from the rod. This step assists you to very easily slide sling hanger off the rod. Now slide the hanger over the housing and by way of the hole offered, lift it out very carefully.

Via the open finish, take away the broken plastic hangers and replace them with new ones. Now fit the new hangers via the finish from the rod as well as the slot. Just make sure that the hanger faces within the forward path.

Once the complete approach is more than, reattach the drapes or curtains around the traverse rods by inserting the hook end from the s-shaped pin, which may be observed on the backside of the pleated drapes.

The same approach can be followed with extra-long traverse rods. Nevertheless, be very carefully whilst reattaching the drapes because the s-shaped hooks includes a sharp pointed finish, which can get poked on your finger.